Mountain Speedway - Family Entertainment in The Pocono Foothills

P.A.L. “OUTLAW” Legends - 2010 RULES

Click for printer-friendly rules

AERODYNAMICS: NO Spoilers, Air Dams, or other aerodynamic devices permitted.

AIR FILTERS: Air filters element must be maximum 3” in height (bottom of filter element to top). No Velocity/Ram stacks allowed.

STARTERS / ALTERNATORS: All cars must be self-starting and have working alternators to keep battery system charged.

BATTERY: Battery must remain in stock location. NO Motorcycle batteries permitted. Battery disconnect switch within reach of Driver is MANDATORY. Must be highlighted in orange.

DRIVESHAFT: Magnetic Steel driveshaft only.

EXHAUST SYSTEM: All cars must have a muffler. Muffler must have some type of baffle.

FUEL SYSTEM: Gasoline only permitted. All cars must have approved Fuel Cell. Fuel shut-off valve required-must be within reach of Driver and clearly marked “Fuel ON-OFF”.

IGNITION SYSTEM: Ignition systems must utilize all OEM stock parts. NO splices or tape will be permitted on Ignition pickup coil wire-wire MUST run directly to ignition box. Absolutely NO Traction Control Devices will be permitted!

REAR ENDS: Only 10 bolt pattern/wide flange (5/8”) Toyota, locked-steel rear ends permitted.

FRAME HEIGHT: All cars must maintain a minimum 3 ½ inch frame height-after race, without driver.

SPRINGS / SHOCKS: Only (1) shock and (1) spring permitted-per wheel.

TIRES: Track tires only. Call (570)788-7544 for tire info.

WEIGHT: Minimum weight = 1300 lbs (after race-with driver seated in car)

Maximum rear weight % = 52.0% (after race-with driver seated in car)

Maximum left side weight % = 52.0% (after race-with driver seated in car)

***ALL Ballast must be securely fastened to frame***

WHEELS: Any 13” diameter by 7” width automotive magnetic steel wheel permitted. Racing wheel highly recommended. Must be 3” backspace (¼” tolerance-will be allowed)

WHEELBASE: All cars must maintain a 73” wheelbase (¼” tolerance-will be allowed) on either side.

TRACKWIDTH: Maximum 60” track width-front or rear, Measured with Tech Official’s gauge.

17. ENGINES: “Sealed” 1250 or Yamaha 1200 permitted.

If utilizing 1200, must maintain 10.0-1 compression ratio and be at or below 165 P.S.I. cranking compression on any cylinder, at any time.

***ENGINES MUST BE MOUNTED IN STOCK LOCATION-NO SETBACK***

TRANSPONDER LOCATION: SEE TECH OFFICIAL for proper mounting location

NOTE: Anything not covered in these rule specifications-will be at the discretion of the Speedway Officials-without recourse from any driver or owner, in the fairness of competition.



CLICK LOGO ABOVE FOR ENDURO PAGE Special thanks to Richie Grodski at "The Chrome Horn" ________________ Speedway Info Sundance Vacations Speedway is a 1/3 mile asphalt oval located in the beautiful mountains of northeast Pennsylvania. The speedway hosts exciting stock car racing every weekend from April to October, making it one of NEPA's premier entertainment attractions. *read more* Sundance Vacations Speedway Mill Mountain Road St Johns, PA 18247 *full directions & map* (570) 788-7544 Sundance Vacations Speedway is available to rent to any team interested in testing their cars. To schedule a date and time please call the track office at (570) 788-7544.	P.A.L. “OUTLAW” Legends - 2010 RULES Click for printer-friendly rules AERODYNAMICS: NO Spoilers, Air Dams, or other aerodynamic devices permitted. AIR FILTERS: Air filters element must be maximum 3” in height (bottom of filter element to top). No Velocity/Ram stacks allowed. STARTERS / ALTERNATORS: All cars must be self-starting and have working alternators to keep battery system charged. BATTERY: Battery must remain in stock location. NO Motorcycle batteries permitted. Battery disconnect switch within reach of Driver is MANDATORY. Must be highlighted in orange. DRIVESHAFT: Magnetic Steel driveshaft only. EXHAUST SYSTEM: All cars must have a muffler. Muffler must have some type of baffle. FUEL SYSTEM: Gasoline only permitted. All cars must have approved Fuel Cell. Fuel shut-off valve required-must be within reach of Driver and clearly marked “Fuel ON-OFF”. IGNITION SYSTEM: Ignition systems must utilize all OEM stock parts. NO splices or tape will be permitted on Ignition pickup coil wire-wire MUST run directly to ignition box. Absolutely NO Traction Control Devices will be permitted! REAR ENDS: Only 10 bolt pattern/wide flange (5/8”) Toyota, locked-steel rear ends permitted. FRAME HEIGHT: All cars must maintain a minimum 3 ½ inch frame height-after race, without driver. SPRINGS / SHOCKS: Only (1) shock and (1) spring permitted-per wheel. TIRES: Track tires only. Call (570)788-7544 for tire info. WEIGHT: Minimum weight = 1300 lbs (after race-with driver seated in car) Maximum rear weight % = 52.0% (after race-with driver seated in car) Maximum left side weight % = 52.0% (after race-with driver seated in car) *ALL Ballast must be securely fastened to frame* WHEELS: Any 13” diameter by 7” width automotive magnetic steel wheel permitted. Racing wheel highly recommended. Must be 3” backspace (¼” tolerance-will be allowed) WHEELBASE: All cars must maintain a 73” wheelbase (¼” tolerance-will be allowed) on either side. TRACKWIDTH: Maximum 60” track width-front or rear, Measured with Tech Official’s gauge. 17. ENGINES: “Sealed” 1250 or Yamaha 1200 permitted. If utilizing 1200, must maintain 10.0-1 compression ratio and be at or below 165 P.S.I. cranking compression on any cylinder, at any time. *ENGINES MUST BE MOUNTED IN STOCK LOCATION-NO SETBACK* TRANSPONDER LOCATION: SEE TECH OFFICIAL for proper mounting location NOTE: Anything not covered in these rule specifications-will be at the discretion of the Speedway Officials-without recourse from any driver or owner, in the fairness of competition.	Click link above for local weather forecast
		Click link above for local weather forecast