2007 Safety Rules
 
1. All cars will be safety inspected prior to being allowed onto track by the Tech inspector
or a qualified official. You must have an inspection sticker on your car at all times.
 
2. All cars will have a suitable 2 lb fire extinguisher, gauge type within drivers reach with a quick release or a fire system.
 
3. All cars will have a fuel shut off valve within reach of both sides of car clearly marked
FUEL-ON and OFF highlighted in orange
 
4. All cars will have a battery shut off switch within reach of both sides of car clearly marked
POWER-ON and OFF highlighted in orange or any bright color.
 
5. Drive shafts in all divisions will be magnetic and painted white, yellow, or orange.
 
6. All cars will have 2 drive shaft safety loops both front and rear.
 
7. All weights added to cars will be within the wheelbase, welded or bolted using
3/8" grade 8 bolts, washers and lock nuts. Added weight must be painted white with car number.
 
8. No electric fuel pumps or glass fuel bowls.
 
9. Tow hooks on the end of each frame rail are mandatory. If your car has a rubber nose or tail.
Two cables each must be accessible through slots in bumper both front and back.
If your car does not comply with this rule, the track crew may push you to the infield so
as to not hold up the show.
 
10. All closed fender divisions must have at least a 90 snell approved helmet or newer.
Open wheel divisions must be 95 or newer. A full face shield or goggles are mandatory.
Full face helmets are recommended.
 
11. All divisions must have a SFI approved fire retardant suit in good condition.
(No holes,rips or patches)
Head sock, gloves, underwear, shoes, horsecollars are highly recommended.
 
12. Nomex gloves will be worn anytime the car is on the speedway.
 
13. No sharp edges of any kind on any car.
 
14. Any fuel line or wire going through panels will be sufficiently grommeted.
If fuel lines or wires come within 2” of any exhaust piping it must be shielded.
 
15. Approved fuel cells only. A minimum 1 ½” bar shall be positioned
behind all fuel cells in a manner to ward off punctures in case of an accident.
 
16. Tip over valve on all fuel cells mandatory on all cars.
 
17. All cars must have an approved aluminum racing seat with a built in headrest.
 
18. All safety belts will be securely fastened to the frame or cage with minimum 3/8” grade 8 bolt.
Shoulder belts shall come over a bar at shoulder height. All belts will share one common
lever type release.
 
19. All safety belts will be no older than 5 years ( 3 years for Mods ).
Belts with no date or are in questionable condition will not be allowed.
 
20. All cars will have a approved driver side window net 18” x 24” secured to the rollcage
that drops down when released.
 
21. Any item covered and not covered in above rules considered falling under the rules of safety
may or may not be given a grace period to repair in order to race that given day.
This will entirely be up to the Tech inspector.
Some of the items in this section are defined in more detail in your divisional rules,
make sure you read and understand all SAFETY RULES.